WHY TUSK?
> Quality > Speed > Performance > Dry cutting > Life span
For use with diamond core drill holesaws.
The SDS end goes in your concrete drill with an SDS or SDS-Plus chuck.
The threaded end goes into a diamond core drill with a 1/2" BSP female thread.
Fits all makes of rotary hammer drills that take SDS bits including Hitachi, Makita, Metabo, Milwalkee, AEG, Bosch, DeWalt etc. If you're not sure if it will fit your power drill then check the manual.
SPECIFICATIONS
Total length 115mm
SDS shank suits SDS chuck
1/2" BSP male thread
Hole for taper shank pilot drill
Hole for drift key to remove pilot drill
NOTES
S.D.S stands for Slotted Drive System. SDS Plus (or SDS+) supercedes SDS yet the two are compatible. It is different to SDS Max which is used on larger breakers, where both the drills and the bits are significantly bigger and more expensive.
A machine will always work, a blade should always cut. TUSK TOOLS are engineered to perform to the highest level
No reviews found