Quality Cutter for detail graving, carving, routing in wood, fiberglass, plastic and soft metals!
FEATURES
Working diameter 0.8mm
Shank 3.2mm
- Secure objects to a stable surface while working.
- For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit.
- Use the sides of the cutter (rather than the tip) for effective cutting. The tip cuts poorly and can break under pressure.
- Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point fo contact).
- If chattering occurs, increase speed.
CONTENTS
1 x Model 108A Engraver
Short Code 108A
Product Code 2615000108
APN 80596001087
No reviews found