Dremel Max High Speed Cutter Ball Nose 6.4mm 2 Pack 117HP 26150117HA

The Dremel Max High Speed Cutter is coated in Titanium Nitride to last 2x longer than the standard, non-coated accessory. It can be used for carving, freehand routing, shaping, hollowing, grooving, slotting, and engraving applications on wood, plastic, aluminium, copper and brass.


FEATURES
Working diameter 6.4mm
Shank diameter 3.2mm
Length 38mm

> Secure objects to a stable surface while working.
> For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit.
> Use the sides of the cutter (rather than the tip) for effective cutting. The tip cuts poorly and can break under pressure.
> Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point of contact).
> If chattering occurs, increase speed.


WHAT YOU GET
2 x Dremel Max Carving Bit 6.4mm


Short Code 117HP
Part Nnumber 26150117HA