The Dremel Max Power Carving Bit is all about speed - 2X faster material removal! Thanks to its tough stainless steel teeth that slice through like butter. Perfect for use in hard-to-reach areas and carving deep holes into your workpiece. Thin and accurate lines can be carved with the tip as well.
Not compatible with Stylo+, Dremel Lite and Dremel 7350.
RECOMMENDED USE
Wood, wood-like materials, plastic, EVA Foam and rubber
SPECIFICATIONS
Shank diameter 3.2 mm
Working diameter 6.4 mm
Material Hardened Stainless Steel
Shape Small taper
Mandrel use No mandrel needed
Max RPM 35,000 1/min
Wood 20,000 – 25,000 RPM
Plastic 15,000 – 25,000 RPM
Short Code 9952
HOW TO USE
> Allow your accessory and Dremel Multi-Tool to handle the task without excessive force.
> For best results, use the sides of the accessory head at an angle less than 90 degrees.
> If you notice excessive chatter instead of material removal, increase the RPM for a smoother outcome.
No reviews found