Dremel Tungsten Carbide bits outlast high speed cutters many times over. Carbide is the hardest material next to diamonds. Use for shaping,smoothing and material removal. Use on hardened steel, stainless steel, cast iron, nonferrous metals, fired ceramics, plastics, hardwoods and other hard materials.
FEATURES
Working diameter 2.4mm
Shank diameter 3.2mm
- Secure objects to a stable surface while working.
- For best results, insert the accessory bit all the way into the tool and then back it out slightly before tightening down. This provides plenty of shank for the collet or chuck to hold onto the bit.
- Use the sides of the cutter (rather than the tip) for effective cutting. The tip cuts poorly and can break under pressure.
- Use higher speeds for hard woods, slower speeds for metals and very slow speeds for plastics (to avoid melting at the point of contact).
- If chattering occurs, increase speed.
CONTENTS
1 x Tungsten Carbide Cutter 9902
Short Code 9902
Product Code 2615009902
No reviews found