Check out these bad boys! It's like a set of little circular saws for your Dremel Rotary Tool.
They work really well on wood and other materials such as plastic and composites etc. With plastic they actually cut instead of melting it like a lot of cutters do. Also good for cutting plasterboard (Gib board) nice and clean for tidy power point cutouts etc.
FOR CUTTING MATERIALS
Hard and soft wood including balsa
Aluminium sheet to 1.0mm
Soft non-ferrous metals
All types of plastic
SPECIFICATIONS
22mm (7/8") 36 teeth 0.7mm thick
25mm (1") 36 teeth 0.7mm thick
32mm (1-1/4") 36 teeth 0.7mm thick
35mm (1-1/2") 36 teeth 0.8mm thick
44mm (1-3/4") 72 teeth 0.8mm thick
Blades are high speed steel (HSS)
Maximum 20,000 rpm
Arbor hole 6.35mm (1/4")
Mandrel 3.2mm shank x 50mm long
WHAT YOU GET
5 x blades
1 x mandrel
USAGE WARNINGS!
1. Only use these blades with variable speed rotary tools and start at the slowest speed.
2. Only use the big 44mm bladefor short periods otherwise you will overheat the motor on your rotary tool.
3. Clamp down your work and hold the tool tight and steady to reduce the chance of jamming.
4. Wear safety glasses and leather work gloves. Keep your fingers away from the spinning blade.
5. When holding the Dremel away from you the teeth shold be pointing in a clockwise direction.
SAFETY WARNING!
These blades are sharp and will cut your fingers off if you're not careful. If you're not good with tools then don't buy these, you will only hurt yourself.
No reviews found