Phone 09 834 0212
Monday to Friday
08.30 am - 4.30 pm
Saturday and Sunday
Email us or call and leave a message
Public Holidays
Email us or call and leave a message
Email info@testntools.co.nz
Address 18 Thomas Hunter Lane
Greenhithe
Auckland
New Zealand
Please note we're an online store and all orders are normally sent by courier. Only a few items are available for collection if required urgently, contact us first to check.
Here's a solution that John from Dargaville came up with to reduce the collet size on his Dremel 732 to 3.2mm (1/8") so he could use the range of Dremel accessories that have 3.2mm shanks.
His Dremel 732 is fitted with a heavy-duty 236 handpiece and reducing collets do exist apparently but are very difficult to find.
The "Dremel Trio Collet Adapter For 3.2mm (1/8") Shank Accessories" we sell has an OD of 5.9mm which will fit inside the 236 handpiece (where the 6mm shank accessories would normally go) so we sent one to try out.
It didn't work out of the box but John was able to machine a small brass taper to fit over the end of the collet. There you go, it works!
Now he can use the wide range of Dremel (and other brand) accessories that have a 3.2mm shank.
John from Dargaville 30/10/2023, 11:43
After all this time I'm still using this method and it works really well. Just as well you made the Dremel Trio collet reducer otherwise I would have been a bit stuck!
© Copyright 2024 Testntools Limited. Prices are in NZD and include GST.