Eastwood Tube Notchers are made from 10mm plate, many other brands are only 6-8mm which doesn't provide enough rigidity for clean, accurate cuts.
With one of these it's easy to prepare pipe joins ready for welding. It notches, capes or saddles any pipe or tube up to 50mm in diameter, round or square. Now it will be a joy making your go-kart, roll cage, sculpture, tubular steel chair or whatever you decide!
Your drill press or power drill goes on one end of the spindle and a bi-metal holesaw (not supplied) goes on the other. The sliding spindle runs on brass bushes and has a holding pin (not shown in photo) to keep the hole saw raised while you're clamping your work in the right position. It can be tilted and rotated so even cutting compound angles is easy.
The 10mm thick backing plate keeps the rig very rigid for consistently accurate notches.
SPECIFICATIONS
Tube capacity up to 50mm
Cuts angles 0-60 degrees
Requires 13mm or bigger drill chuck
Sliding spindle shaft 19mm
Holesaw arbors 1/2" and 5/8"
Supplied with spindle locking pin
Instructions included
Weight 2.9 Kg
No reviews found